The 3 most common comments I hear regarding earpieces on our exhibition stands are:
- My earpiece falls out when I move.
- My ear itches after a while.
- How do I get a molded earpiece made.
Most earpieces are supplied to fit the largest ear. As a result the tube is generally too long and the earpiece tends to fall out. A well fitted earpiece will sit comfortably behind your ear lobe and not ride up above it when you place your earpiece into your ear. You can check to see if this happens using a mirror or ask a colleague to check.
If this does occur it is easy to fix. It is a simple case of trimming the tube to length using a decent pair of scissors. First remove the eartip. Next pull out the right angled joiner that the tip was fitted over from the acoustic tube. It might resist as the tube has expanded to accept the joiner but it is possible.
 |
| Earpiece 90 degree right angle joiner |
Now replace the tubing over your ear and note the correct position of the end of tubing where you put the eartip into your ear. It will be more accurate if you can allow for the short length of the right angle joiner. Remember it is always easier to cut off a little more tube, it is impossible to put it back on!
Before using the scissors remove the acoustic tube from over your ear.
 |
| Earpiece fitting adjustment instructions |
Push the right angle joiner back into the acoustic tube and fit the eartip.
Did you know if you swing the right angle joiner 180 degrees in the opposite direction you can use your earpiece as a Left or Right side earpiece.
Finally the clip should be attached to you collar at the position on you collar so that when you turn your head to the opposite side it the coil expands without pulling your earlobe down and when you turn to the same side it does not pile out onto your shoulder (in TV world it stays out of shot).
You may need to adjust the length of the tube from the end of the coil to the collar clip.
 |
| Earpiece Collar Clip |
Finally if your earpiece still falls out it is time to consider either a semi custom earpiece insert such as a Skeleton eartip or a custom molded earpiece - more on these items to follow on our blog.
